3DPMiniatures

  • CURA Version 1 Vs Version 2

  • Discussion related to preparing 3D models to print with specific slicers
Discussion related to preparing 3D models to print with specific slicers
 #50  by krouton3
 Sun Jan 08, 2017 3:58 am
i should try using cura again last i had tried i was new to 3d printing so its default settings werent cutting as well as matter control did but now that i have more understandings i should try and get those settings dialed in

but i have a robo r1 so cant really help ya there lol