Page 1 of 1

CURA Version 1 Vs Version 2

PostPosted:Sat Jan 07, 2017 10:04 am
by Dangerous Pete
I'm using version 1 for Cura I've tried version 2 but I can't get it to work with my Prusa i3 (clone)

I currently use more or less the same settings as Matt from printable Scenery http://www.printablescenery.com/knowled ... sa-i3-mk2/

Anyone had any luck with Cura 2 on the i3

Re: CURA Version 1 Vs Version 2

PostPosted:Sun Jan 08, 2017 3:58 am
by krouton3
i should try using cura again last i had tried i was new to 3d printing so its default settings werent cutting as well as matter control did but now that i have more understandings i should try and get those settings dialed in

but i have a robo r1 so cant really help ya there lol